Tesla Model 3 Condenser Cleaning

Printed on a Prusa Mini - I used the slicer to cut the object and print in two sections. Basic superglue to connect them.

If you live in a area where you need to clean the AC Condenser on your Model 3, you can follow the guide below. Instead of MacGyvering the foam applicator - print this model. I've included a small hole that can easily be drilled out to larger sizes depending on what foam applicator you end up with. Or, edit the file yourself!

NOTE: This procedure should be done in tandem with replacing the cabin air filters with new ones. In addition, cleaner will drain from bottom of vehicle underneath the evaporator. Make sure you position vehicle in an appropriate area for this, such as an outside driveway.
1. Open cabin air filter cavity, then remove old air filters and set aside for now. Assuming the procedure goes well, they will be discarded at the end of the process.
2. Cover side hole on device with scotch tape.
3. Insert device into cavity, and slide it down to