Slicer Discord
Tesla Model 3 Vent Cover – Modèle 3D imprimable de Thingiverse Thingiverse
Tesla Model 3 Vent Cover – Bild 1 Tesla Model 3 Vent Cover – Bild 2 Tesla Model 3 Vent Cover – Bild 3 Tesla Model 3 Vent Cover – Bild 4 Tesla Model 3 Vent Cover – Bild 5 Tesla Model 3 Vent Cover – Bild 6
Automotive

Tesla Model 3 Vent Cover

215 Téléchargements
131 Likes
1 Makes
Voir le modèle
This is a vent cover for the Tesla Model 3. Since it is not possible to turn off the fan air flow between the driver and passenger independently, this vent cover allows you to effectively block the air flow for either the driver or passenger.

The vent cover is made up of 5 parts: left end cap, right end cap, and three middle sections. I used 2-56 threaded rods to hold all the pieces together, then wrapped the cover with 3M brushed black vinyl.

The cover can be pushed behind the center display when not being used (the vents are closed in that section). It has a slight friction fit so it shouldn't slide around. It can be slid to either the driver or passenger side, and it stops before the side mirror directional vent, also a friction fit to hold it in place.

When the fan is on the higher settings (e.g. 7+), it may lift upward a little due to the air pressure, but it should still hold in place and block the air.

Print all the parts vertical, if possible. no supports needed.
Catégorie
Automotive
Source
Thingiverse
Publié
Ce qu'il faut pour imprimer: Avancé Confiance faible
Pourquoi ?
assemblage en 5 parties
5 pièces à assembler
Supports 1/3
Assemblage 2/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 1/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
PLA
Post-traitement
Collage
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection