Thingiverse
Test Part
von taheilers
0
Downloads
1
Likes
0
Makes
This is a simple test part requested by a community member. The requirements given were:
6 inch disk 1 inch thick with 7 holes in it.
Both the diameter and the spacing of the holes are customizable up to 2 inches in 0.05 inch increments, as anything larger will exceed the 6 Inch diameter of the part itself.
All dimensions are in inches and are converted to millimeters within the code.
6 inch disk 1 inch thick with 7 holes in it.
Both the diameter and the spacing of the holes are customizable up to 2 inches in 0.05 inch increments, as anything larger will exceed the 6 Inch diameter of the part itself.
All dimensions are in inches and are converted to millimeters within the code.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!