Test Print| The EVERYTHING tester

This is a all in one 3d printer test. Below are some things it tests. I did not go too in detail if you want to know how to tune your printer just google it or ask me in comments. :D Design by me in onshape. Calibration- see how close your printer can get to these dimensions. Speed and reliability tests- If you make your printer print faster than it should it may mess up at the lattice cube. This will see if your printer can reliably print fast. It also needs overhangs, and test for stringing. Inspired my Makermuses lattice cube but designed totally on my own. Overhang tests- the two cone shaped parts are 45 degrees and 50 degrees. Bridging test- The gap between the two upside down cones in about 35mm max length. Vertical text readability- There the word “can” is sticking out 0.8mm the word “you” is sticking out 0.5 mm. The word “read” and this is subtracted inwards 0.8mm and the word “this” is subtracted inwards 0.8mm. I added this in here so that when you design your parts you can se