Thingiverse
TEVO Flash Bed Cable Support
door TD3DP
60
Downloads
31
Likes
3
Makes
Bed cable support for the new TEVO Flash. Holds in place with the rear bed screws and springs. The springs fit up inside the hollow posts which allow some clearance between the underside of the bed and the bracket.
It's a nice tight fit to the threads which need to be inserted perpendicular or it'll be very hard to get them on, however it's a nice snug fit.
PETG or ABS would be a good idea due to potential of warping from continued heat exposure.
Supports from platform required for the hollow posts. I printed mine at 45% but I'm pretty confident 25%-35% should be a heap and strong enough.
It's a nice tight fit to the threads which need to be inserted perpendicular or it'll be very hard to get them on, however it's a nice snug fit.
PETG or ABS would be a good idea due to potential of warping from continued heat exposure.
Supports from platform required for the hollow posts. I printed mine at 45% but I'm pretty confident 25%-35% should be a heap and strong enough.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!