Thingiverse

TEVO_PSU_cover

by DoctorDave

23 Downloads

12 Likes

1 Makes

This thing was modeled after TevoPrinter's thing, except that I needed different front-end connections and I created a mount for the rear of the unit so the PSU rests level on the table. The covers were created for the S-300-12, the power supply which came with the Tevo Tarantula.

The main motherboard power lines are connected through the powerpole connectors, and the fans are connected through the 2.1x5.5mm connectors. When power is on, the green LED turn on. If the fans are not connected, the red LED turns on to warn that the electronics and the hotend heatsink are at risk of heating.

Using this thing allows one to totally disconnect the power supply from the 3Dprinter, and protects one from accidentally coming in contact with the power mains if wires are dislodged.

Source

Thingiverse

What you need to print this: Beginner Low confidence

Single piece

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer

FDM / FFF

File format