Tevo Tarantula Brackets

Just some brackets to firm up the little spider =)

Will need 1 of each, and 2 of the Y_Base.

I didn't add any tolerance in the drawing so it may be a tight fit depending on printer setup.
There is a gauge to check fit and make adjustments to your printer or scale before printing the larger pieces.

These are stout enough that you can leave a 5mm gap on the ends of the 2 short 2040 on the base and a 20 mm gap on the upper z mount corner to give you 20mm more x travel. This is nice if you have a wider x carriage. Can also easily raise the Z legs 20mm, but not needed to get the full 200mm z.

*** Make sure your printer is square when you print these. I set them up to lock it down and if your printer is out of whack, they and your printer will be after installing.***

I run this adjustable z stop. Use the short version with the these brackets.
http://www.thingiverse.com/thing:1439423

**These things are a major pita to install with the stock style tnuts. Search ebay/ali/wh