Thingiverse
Tevo Tarantula Slim Case
von ziggybozbo
244
Downloads
163
Likes
1
Makes
ATTENTION: Like the orange banner says above, this piece really is a work in progress. I'm happy to make any small modifications if you let me know ahead of time. I will upload files upon request.
Two pieces have variants: The front-top panel (can have power button hole or no hole) and the rear panel (can have standard C14 cutout or fused C14 cutout).
_______
I really like the concept of logan's well-known Extended Case. This is my spin on it to fit a few extra design criteria:
* All sides should fit on the Tarantula's large printing bed (28x20cm) with no gluing of two halves required
* Enclosure needs to hold MKS board, power supply, discount display, and a mosfet board
* Lots of air flow! 120mm fan desired
* Case should generally be as small as possible, preserving all above requirements
This design I've made achieves all this, and I think it's an ideal choice to give the Tarantula a sleek and tidy look.
Required Hardware:
Like logan's design, you'll need pl
Two pieces have variants: The front-top panel (can have power button hole or no hole) and the rear panel (can have standard C14 cutout or fused C14 cutout).
_______
I really like the concept of logan's well-known Extended Case. This is my spin on it to fit a few extra design criteria:
* All sides should fit on the Tarantula's large printing bed (28x20cm) with no gluing of two halves required
* Enclosure needs to hold MKS board, power supply, discount display, and a mosfet board
* Lots of air flow! 120mm fan desired
* Case should generally be as small as possible, preserving all above requirements
This design I've made achieves all this, and I think it's an ideal choice to give the Tarantula a sleek and tidy look.
Required Hardware:
Like logan's design, you'll need pl
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
