Thingiverse
Tevo Tarantula Z Axis Stabilization Bracket
di Tinic
455
Download
241
Likes
7
Makes
This is a stabilization bracket for the Tevo Tarantula printer. In the stock printer the Z-Axis 'floats' on the flexible shaft coupling which creates some vibrations and compromises rigidity.
To install this you need 1) a standard 8x22x7 bearing and 2) some sort of 8mm shaft collar and 3) 2 x 4mm T-nuts and M4 bolts, which you should already have. The bearing and collar are available for cheap on Amazon. I made my shaft collar on my lathe but you can as well print your own using pretty much any material, see http://www.thingiverse.com/thing:400921
Sample Amazon listings:
https://www.amazon.com/Skateboard-Bearings-Double-Shielded-Silver/dp/B002BBGTK6
https://www.amazon.com/Ruland-MSP-8-SS-Two-Piece-Clamping-Stainless/dp/B0063L7GZW
I did print this bracket with 100% infill for maximum rigidity.
I recommend to place a 8mm washer (or something close to that) between bearing and collar so that the collar does not rub on the shielding of the bearing. In my case the shielding
To install this you need 1) a standard 8x22x7 bearing and 2) some sort of 8mm shaft collar and 3) 2 x 4mm T-nuts and M4 bolts, which you should already have. The bearing and collar are available for cheap on Amazon. I made my shaft collar on my lathe but you can as well print your own using pretty much any material, see http://www.thingiverse.com/thing:400921
Sample Amazon listings:
https://www.amazon.com/Skateboard-Bearings-Double-Shielded-Silver/dp/B002BBGTK6
https://www.amazon.com/Ruland-MSP-8-SS-Two-Piece-Clamping-Stainless/dp/B0063L7GZW
I did print this bracket with 100% infill for maximum rigidity.
I recommend to place a 8mm washer (or something close to that) between bearing and collar so that the collar does not rub on the shielding of the bearing. In my case the shielding
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
