Tevo Tornado Horizontal spool holder

Support for base only, printed on front side
Stainless Steel bearings form Mcmaster Carr #9291K47 -1/4" diameter 304 Stainless.
Trim ring flipped so that bead side is against bearings for smoothness.
Bearing cover printed at .15 layer height
Spool base printed at .30 layer height for speed.
Print 2 Bearing covers and oppose them to hold bearings.
Glue trim ring at bottom of spool shaft (bed side up)
Glue 1st Bearing cover centered on spool holder shaft, add bearings
Glue 2nd bearing cover centered on spool holder.
Clamp until glue is cured
Used IPS Acrylics adhesive. CA should also work.
Fits over Control box of Tevo and Creality CR10 machines