Tevo Tornado Y stepper reinforcement

The Y stepper motor mount is very wobbly because of the thin aluminium bracket used by Tevo.
So i decided to reinforce it with a minimum of disassembling. You only need to unplug the motor cable. To attach the bracket you need one of the spare t-nuts given by Tevo an one 15mm M5 allen screw with a washer. Before you tighten the screw make sure the stepper motor is under a little bit of tension and the bracket is situated next to the motor cable plug. So the reinforcement is the most.

Based on your printer calibration the bracket should fit smoothly. Make sure the brace not colliding with the silikon heat bed. Otherwise you must relevel the bed a little bit higher.

Maybe you have to slide the Y endstop a little bit to the front for good contact. For me i adjust 3-5mm