TF-2飞鹰号螺旋桨战斗机（Propeller fighter jet）

这是我原创武器载具三部曲之空战系列飞机之一，代号TF-2,中文名“飞鹰”。乃是平行宇宙中的一款赛博朋克风螺旋桨高速战斗机，主要功能对空作战，其搭载四门30毫米机炮，机翼下可挂载6枚红外制导空空导弹。飞机采用气冷V10发动机，有效马力高达1000匹，拥有近600公里的作战半径。机身采用传统后三角固定式起落架布局，方便维护。（以上是我对该飞机的性能参数设定，仅供娱乐）。 This is one of the aerial combat series aircraft in my original weapon vehicle trilogy, codenamed TF-2 and Chinese name "Flying Eagle". It is a cyberpunk wind propeller high-speed fighter jet in a parallel universe, mainly used for air combat. It is equipped with four 30mm machine guns and can carry six infrared guided air-to-air missiles under its wings. The aircraft uses air-cooled V10 engines with an effective horsepower of up to 1000 and a combat radius of nearly 600 kilometers. The fuselage adopts a traditional rear triangle fixed landing gear layout, which is convenient for maintenance. (The above are my performance parameter settings for the aircraft, for entertainment purposes only). 模型尺寸为长126毫米，宽170毫米，高63毫米，差不多成人巴掌大小。 The model dimensions are 126 millimeters long, 170 millimeters wide, and 63 millimeters high, approximately the size of an adult palm. 用到的工具（tool）： 尖嘴钳long-nose pliers 胶水glue   注意事项（Precautions）： 模型零件较小，所有从打印机拿下来的时候请小心，避免丢失或掰断； The model parts are small, please be careful when removing them from the printer to avoid loss or breakage; 除了轮胎和螺旋桨不需要用胶水固定外，其余部分均使用胶水固定； Except for the tires and propellers that do not need to be fixed with glue, all other parts are fixed with glue; 后起落架固定轴比较细小，安装时候请小心； The fixed shaft of the rear landing gear is relatively small, please be careful during installation; 打印前请清洁打印板，做好耗材烘干处理和流量校准； Please clean the printing board, dry the consumables, and calibrate the flow rate before printing;