Thingiverse
TF PotP Cranium Controller Blank Figure
door WayGroovy
29
Downloads
22
Likes
0
Makes
Designed in Tinkercad and printed on Creality Ender3 and CR-10.
PLA, 0.16 layer height, 1.6 wall thickness, 0.48mm top/bottom thickness, 5% infill, Lines support 73° 15% 0.04 support z-distance, no build adhesion. Sliced in cura to about a 30 minute print, all at once.
https://www.tinkercad.com/things/9cRoQVqh1B5
They are assembled at the waist and knees with a thin wire or paperclip. I left a groove to bend a bit extra up around, to keep it locked and out of the way.
PLA, 0.16 layer height, 1.6 wall thickness, 0.48mm top/bottom thickness, 5% infill, Lines support 73° 15% 0.04 support z-distance, no build adhesion. Sliced in cura to about a 30 minute print, all at once.
https://www.tinkercad.com/things/9cRoQVqh1B5
They are assembled at the waist and knees with a thin wire or paperclip. I left a groove to bend a bit extra up around, to keep it locked and out of the way.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!