Thingiverse
TFT 2.2 LCD Holder
por Stoney
11
Descargas
7
Likes
0
Makes
A small mountable holder for a fasttech LCD module.
Mounting pins are a little tight but can be snapped off if not needed.
Mount holes are designed for assorted leg or spacer designs.
Holes are 5mm dia, 34mm apart and hole centre 5.5mm from edge if you want to make different legs for it.
Also printed the arduino due case at http://www.thingiverse.com/thing:109740 and the "duo case pins" files are made so that the pins on this bracket fit into the holes on the case.
"lcd hinge" is for behind the lcd.
"base hinge" fits into the duo case pins and takes the lcd hinge shaft
My hinge snapped when I tried to jam the shaft into it, blue pvc pipe glue visible on assembled photos.. does the job.
Mounting pins are a little tight but can be snapped off if not needed.
Mount holes are designed for assorted leg or spacer designs.
Holes are 5mm dia, 34mm apart and hole centre 5.5mm from edge if you want to make different legs for it.
Also printed the arduino due case at http://www.thingiverse.com/thing:109740 and the "duo case pins" files are made so that the pins on this bracket fit into the holes on the case.
"lcd hinge" is for behind the lcd.
"base hinge" fits into the duo case pins and takes the lcd hinge shaft
My hinge snapped when I tried to jam the shaft into it, blue pvc pipe glue visible on assembled photos.. does the job.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
