TFT35 E3 Angled Display Mount Assembly

ThinkING_3D's design for an angled mount for a BTT TFT35 E3 was inspired, but difficult to print as it requires a fair amount of supports. On a suggestion, I split the arm off of the display case, meaning both parts can be printed face down on the print bed without any supports at all.

Choose either the arm that you can insert threaded inserts into, or the one where you can screw into the plastic directly. The holes are fairly deep, meaning you can use M3x8 screws if you don't have any M3x6 screws lying around. I used low profile socket cap screws, but any M3x6-8 bolt should work fine as long as their heads aren't too wide. Two sets of M4x8 bolts and T-nuts were used to attach the display to a vertical 20mm aluminum extrusion.

Fusion 360 and STEP files attached for your remix pleasure.