TFT35-E3 case for Ender 5 Plus

Enclosure for BigTreeTech TFT35-E3 dual-mode screen, for replacing the standard display on the Ender 5 Plus.

Requires a total of nine M3 bolts. M3 × 8 mm (or longer - up to 12 mm) ×7 – four for holding the TFT35-E3 board between the Back and Front (ensure that the Button is placed before closing the case), and three for securing the Mount to the Back (install Mount inside E5 Plus case, where old display was located). M3 × 8 mm (or longer - up to 20 mm) ×2 – for securing the Rear to the Back.

Screw-holes have been left in the corners of the Back and Front, but should not be required. The four screws that sandwich the TFT35-E3 between the Back and Front should be sufficient.

Pre-thread the M3 bolts to make final assembly easier.

You will need to print the following:
• TFT35-E3_Front_rev4
• If no WiFi modue: TFT35-E3_Back_rev4.stl
• If a WiFi modue installed: TFT35-E3_Back_rev4_wifi.stl
• TFT35-E3_Rear_rev4.stl
• TFT35-E3_Mount_rev4.stl
• TFT35-E3_Button_short.stl or TFT