TH3D EZABL Pro Support Bondtech DDS

I made this support for the TH3D EZABL Pro (18 mm) sensor for the Bondtech DDS. I had tried another, but then realized that it covered up the sensitivity adjustment screw. This one is long enough that it will not interfere with the adjustment screw. The bracketry is also minimal to prevent hindering air flow to the hot end heat sink. I printed it out of ABS because that is what I had in black, but it should also work just fine in PLA…not much stress just holding the sensor. I did print it with 100% infill just to prevent any possible flexing happening.