The 3D Printers Scepter (Modular creators scepter)

Inspired by my fully 3D printed walking stick I created this scepter for 3D Printing Royalty!This is a colour change intensive print and is ideally intended to be printed on an H2D, or preferably an H2C. The sectionsThis prints across 4 plates, including 3 sections, the nozzle cap, and screws to fit them all together.You can fit the 3 long sections in whatever order you like, you could also print as many as you want so you can make this as long or short as desired. As in the photos, the cap is a large Brass 0.4mm nozzle, then it's a stack of 3D printers, then there are two lengths of Filament spools stacks. The first is just filament top to bottom, and the second has a smaller nozzle fitted on the base. AssemblyOnce printed, just take one of the screws and screw it into one of the main parts. Then take another part and screw onto the opposite end of that screw. Turn them both to tighten it up.Please note: It will screw so the parts are completely flush but don't over tighten as