Thingiverse
The Best Flowrate Calibration Method!
par petrzmax
3.1k
Téléchargements
1.7k
Likes
4
Makes
If You enjoyed this guide and You want to say "Thank You" please consider supporting me by sending a tip on thingiverse or my PayPal here.
I have tested a lot of different flowrate calibration methods on the internet but methods I found were not accurate, time-consuming or just were not working for me. This is the method I have elaborated by merging a few other methods and adding some my expirence.
Check my I3 Mega **ULTIMATE upgrade guide!** There is a lot of knowledge which may help You get the best 3D printing results and make Your 3D printer silent. You will find it here:
- http://bit.ly/2OVbu5Z
**Attention!**
Before calibrating flowrate make sure that Your E-Steps are well calibrated. Otherwise, you will waste your time. Also make sure that filament which You are using is good quality - Ø tolerance is not bigger ±0,05 mm. Do not use no-name filaments because their diameter may be fluctuating and it will be impossible to achieve stable results.
**How to calibrate
I have tested a lot of different flowrate calibration methods on the internet but methods I found were not accurate, time-consuming or just were not working for me. This is the method I have elaborated by merging a few other methods and adding some my expirence.
Check my I3 Mega **ULTIMATE upgrade guide!** There is a lot of knowledge which may help You get the best 3D printing results and make Your 3D printer silent. You will find it here:
- http://bit.ly/2OVbu5Z
**Attention!**
Before calibrating flowrate make sure that Your E-Steps are well calibrated. Otherwise, you will waste your time. Also make sure that filament which You are using is good quality - Ø tolerance is not bigger ±0,05 mm. Do not use no-name filaments because their diameter may be fluctuating and it will be impossible to achieve stable results.
**How to calibrate
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
