Other STL Download - The Bunnyby 3DGeex

Hey folks! Update 25.08.25 The Optic Nerve had a bit too high tolerance which could cause the joints to disconnect depending on your settings. I added a new version - Optic_Nerve_lower_tolerance.stl which addresses this issue. Say hello to The Bunny - His functional part is a Pen Holder! When not used you can close his eye with his lose optic nerve 👁️ This is probably the most files I ever had in a single project so I need to explain myself 😅 Please read the instructions and explanations below. The Bunny has 3mf pre-colored versions and an almost full multipart version - Excluding teeth. Multipart bunny versions end with Multipart. The Multipart versions also have 3mf versions because the teeth are not multipart so I included pre-colored files. Although there are 16 (!!) bunny files - The bunny has just 2 variations - A full ear and a bone ear. Why so many files?? When I was done designing and print testing I realized I can get slightly better results if I tilt the bunny to prevent support requirements in the face area - This is why each version has a TILTED_ version as well. The TILTED version requires less supports and in areas that are not seen - Back of the ears and back of the front paws. It also uses slightly less poop with AMS. But this is a preference thing and each version has it's cons and pros in terms of supports scaring so check the comparison photo to see the differences - Your support settings will obviously make the most difference in both cases. I also recommend printing the Multipart versions simply to avoid waste - Unless you are printing multiple pieces together which will reduce the waste significantly. Assembly & Printing: Tilted versions requires printing the Tail.stl and gluing it separately. All bunny versions require supports, as mentioned tilted version will require less and will leave less scaring. All other do not require supports. Articulated eye parts: Optic_Nerve -> Optic_Nerve_Eye -> Optic_Nerve_Pupil Big eye parts: Big_Eye