Slicer Discord
The Bunny – Modelo 3D imprimible de MyMiniFactory MyMiniFactory
Home & Decor

The Bunny

0 Descargas
1 Likes
0 Makes
Ver Modelo
Hey folks! Update 25.08.25 The Optic Nerve had a bit too high tolerance which could cause the joints to disconnect depending on your settings. I added a new version - Optic_Nerve_lower_tolerance.stl which addresses this issue. Say hello to The Bunny - His functional part is a Pen Holder! When not used you can close his eye with his lose optic nerve 👁️ This is probably the most files I ever had in a single project so I need to explain myself 😅 Please read the instructions and explanations below. The Bunny has 3mf pre-colored versions and an almost full multipart version - Excluding teeth.Multipart bunny versions end with Multipart.The Multipart versions also have 3mf versions because the teeth are not multipart so I included pre-colored files.Although there are 16 (!!) bunny files - The bunny has just 2 variations - A full ear and a bone ear.Why so many files?? When I was done designing and print testing I realized I can get slightly better results if I tilt the bunny to prevent sup
Categoría
Home & Decor
Fuente
MyMiniFactory
Publicado
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

3DGeex también publica en

15 modelos adicionales en 3 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección