The challenge

Simple but most important test to do.
Printing in vase mode at maximum height that you can reach, the speed is not important, like 30-50 mms is ok.

With this simply test can ceck some important things:

-Alignment XZ and YZ;
-Alignment between Tr8-nut-stepper motor;
-Goodness in particular of Z linear rail.


With a bracket resting on the bed as you can see in the picture if you want to publish your prints, to better show the quality of assembly and of the assembled components. This is not a race but they are a test for us to allow us to improve :)

I hope you will take the test with the right constructive spirit, to further improve the quality of our prints by correcting things that we might not notice.
A special thanks to Ben for his project. Have fun:)