Thingiverse
The Chlorinator
door messy-messer90
0
Downloads
1
Likes
0
Makes
Printed on a Bambu Labs P1S.
Material - ASA
Float - 10% infill
Dispenser - 30% infill
Flow cap - 50% infill
Dispenser will screw into the float and the flow cap snaps on to the dispenser. The flow cap is a snug fit, might have to sand a little and give it a few smacks should snap into place.
Dispenser screws/unscrews into float to fill with chlorine. Fits 1 inch hot tub chlorine tabs.
Material - ASA
Float - 10% infill
Dispenser - 30% infill
Flow cap - 50% infill
Dispenser will screw into the float and the flow cap snaps on to the dispenser. The flow cap is a snug fit, might have to sand a little and give it a few smacks should snap into place.
Dispenser screws/unscrews into float to fill with chlorine. Fits 1 inch hot tub chlorine tabs.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!