The Essential Calibration Set

Those tests includes: .5mm thin wall20mm box20mm hollow box50mm towerperimeter width/t testerprecision blockoverhang testoozebane testbridge testFirst here is the .5mm thin wall. This is for layer height testing. Print this and make sure that the layers adhere well but the nozzle does NOT drag through while printing. Adjust layer height by .01 increments.Next is the 20mm test box. This is for making your prints nice and pretty. Set infill solidity to 1.0 for this. Print this and analyze the top. If there is NOT ENOUGH plastic, turn down Infill Width over Thickness by .05 increments. If there is TOO MUCH plastic, turn that parameter up by .05 increments. Once you're feeling close, start bumping it around in smaller increments. Another path to take here is to adjust your feedrate a bit. Adjust the feedrate by increments of 2 or so until you feel close. If it looks really disgusting and blobby, go by increments of 5.mThen go by smaller and smaller increments until you've nailed it