Thingiverse
The Expanse OPA Coasters
by ctbaker
47
Downloads
32
Likes
0
Makes
Wanted to make some drink coasters but wasn't sure what design to go with. While searching, I stumbled across the idea of The Expanse logos and turning them into coasters. I took some existing OPA logos, traced new versions in Fusion360 and then created coasters for them.
The coasters are 102mm in diameter and are set up as 2-color prints with 0.3mm clearances to allow the pieces to snap together so gluing is not required
The coasters are 102mm in diameter and are set up as 2-color prints with 0.3mm clearances to allow the pieces to snap together so gluing is not required
ctbaker also publishes on
24 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!