Electronics
Zum Modell
The Helping M
109
Downloads
139
Likes
0
Makes
The Helping M is a very portable clamp to help you hold in components during soldering jobs.
I started on this _after_ hand-soldering the 52 SMT components for the HBP :-P
1. There is no need to bend the component wires to hold in the component during soldering
2. Adapts to different sizes of circuit boards: Max about 7 to 8 inches wide
3. With some velco, interchangeable heads allow usage for capacitors, resistors, ICs
4. Once mounted, The Helping M is able to move laterally to press on different components
5. The Helping M slides up and down your board easily too
6. The Helping M also serves as a prop when you flip the circuit board around, to position the board in the right position to solder easily
I started on this _after_ hand-soldering the 52 SMT components for the HBP :-P
1. There is no need to bend the component wires to hold in the component during soldering
2. Adapts to different sizes of circuit boards: Max about 7 to 8 inches wide
3. With some velco, interchangeable heads allow usage for capacitors, resistors, ICs
4. Once mounted, The Helping M is able to move laterally to press on different components
5. The Helping M slides up and down your board easily too
6. The Helping M also serves as a prop when you flip the circuit board around, to position the board in the right position to solder easily
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!