Thingiverse
(The Linear) lightsaber
von Aos4life
49
Downloads
34
Likes
0
Makes
This lightsaber is 'The Linear', named by Frank Roop III.
I have provided a full saber model as well as a 3 part sliced version.
It is designed to allow a 1 inch OD PVC pipe or similar as the blade, using an M4 screw (or any type of pin that is 0.15 inches) as a blade holding pin. as long as my measurements are correct that is.
I have test printed it and it turned out better than expected. it should print flawlessly as long as you use supports for the pommel and grip.
I do this in my spare time, so if you print it and like the way it turned out, shoot me a tip!
If you print it, please share some photos, I'd love to see them!
I have provided a full saber model as well as a 3 part sliced version.
It is designed to allow a 1 inch OD PVC pipe or similar as the blade, using an M4 screw (or any type of pin that is 0.15 inches) as a blade holding pin. as long as my measurements are correct that is.
I have test printed it and it turned out better than expected. it should print flawlessly as long as you use supports for the pommel and grip.
I do this in my spare time, so if you print it and like the way it turned out, shoot me a tip!
If you print it, please share some photos, I'd love to see them!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
