Thingiverse
The LithoLight
door heyerconception
73
Downloads
54
Likes
0
Makes
This is my LithoLight.
PS: If you are here for the avatar litho, i've included that as well, but I may make a seperate thingiverse link - I used hatchbox mint PLA for that.
IMPORTANT UPDATE 12/19/18: I have once again redesigned the LithoLight to accommodate a press-fitted side switch (https://www.amazon.com/gp/product/B07B2S5QYN/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1), that means no glue! Technically you can press fit everything together, but you may still want to use a bit of glue on the casing itself, and the back on the circuit board.
IMPORTANT UPDATE 12/9/18: I have redesigned the LithoLight to be more accomodating and far cleaner looking. The pieces actually snap fit together now, and seams are covered, making it look much nicer. A little glue is still recommended upon snapping everything (Front_3 and Back_3) together. ALSO, I have sourced BRIGHTER and CHEAPER nightlights on Amazon, and they are even easier to disassemble AND DONT REQUIRE A RESISTOR, just solder the
PS: If you are here for the avatar litho, i've included that as well, but I may make a seperate thingiverse link - I used hatchbox mint PLA for that.
IMPORTANT UPDATE 12/19/18: I have once again redesigned the LithoLight to accommodate a press-fitted side switch (https://www.amazon.com/gp/product/B07B2S5QYN/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1), that means no glue! Technically you can press fit everything together, but you may still want to use a bit of glue on the casing itself, and the back on the circuit board.
IMPORTANT UPDATE 12/9/18: I have redesigned the LithoLight to be more accomodating and far cleaner looking. The pieces actually snap fit together now, and seams are covered, making it look much nicer. A little glue is still recommended upon snapping everything (Front_3 and Back_3) together. ALSO, I have sourced BRIGHTER and CHEAPER nightlights on Amazon, and they are even easier to disassemble AND DONT REQUIRE A RESISTOR, just solder the
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
