The Nuke light box

von Jay · Decor

171 Downloads

68 Likes

78 Makes

The nuke light box DEC 27 2024 - I added some fillets to the inside of the box for easier installations of cover plate the cover plate is scaled down because of the tight fit with the box, it will be easy to install but difficult to take off. if needed scale down further. Also two cover plates are available one where both yellow and purple are set to 0.6mm and the other where yellow is only set to 0.6mm. Boost Mefor more 180's!!!

darts dart dartboard dart board winmau harrows target luke littler the nuke 501 pdc e darts dartslive gran board granboard steel tip soft tip autodarts scolia omni

Kategorie

Decor

Quelle

MakerWorld

Veröffentlicht

21.12.2024

Aktualisiert

30.04.2026

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat

STL

Material

PLA

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

The Nuke light box

Ähnliche Modelle

Zur Sammlung hinzufügen