Thingiverse
The Pegboard Project
von RecycledHiker
70
Downloads
51
Likes
0
Makes
Yes, I know that pegboard has been done. Now it has been done again. And in such pretty colors !!.
I got the basic pegs design in SCAD for here:
https://www.thingiverse.com/thing:1997501
And then made custom SCAD code for each of the holders that were not screwdrivers.
the pegboard I did in parameterized SCAD.
I may be able to print bigger than 6x6, but I was thinking that 3 of them would fit into the 18 inch stud to stud spacing in my house. There are screw holes and wall offsets integrated.
The MKVI scad version mainly has larger screw holes.
The tool holders I show here are mostly for all of the tools that either come with or I use with the Ender3. Including the little wrenches and Allens. There is also a holder for a fine precision adjustment device (see lower left of full peg board).
I got the basic pegs design in SCAD for here:
https://www.thingiverse.com/thing:1997501
And then made custom SCAD code for each of the holders that were not screwdrivers.
the pegboard I did in parameterized SCAD.
I may be able to print bigger than 6x6, but I was thinking that 3 of them would fit into the 18 inch stud to stud spacing in my house. There are screw holes and wall offsets integrated.
The MKVI scad version mainly has larger screw holes.
The tool holders I show here are mostly for all of the tools that either come with or I use with the Ender3. Including the little wrenches and Allens. There is also a holder for a fine precision adjustment device (see lower left of full peg board).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!