The PolyBasket - Stackable Desiccant Trays

There are a couple of other trays out there for drying desiccant in your PolyDryer, but I wasn't quite happy with any of them for one reason or another. So I drew this one up with the following goals:Should not hit the inlet rubber when being insertedShould allow for high airflowShould be stackable to increase capacity if neededShould be able to be put away without taking much spaceShould be able to easily pour silica beads out of itAny interface with the box needs to be printed in a durable orientationI think I hit all those points with this design, and with no supports needed 😁 There is a channel in the basket that the arms feed in to so the basket hangs from them.This is a fairly snug fit, so if you used ASA like I did (and thus had to use a brim) you may need to do a little cleanup with a hobby knife. If you use my profile, I intentionally set the brim gap to 0.02mm so it ensures a strong bond to combat warping. You can stack up to three boxes on these arms, supporting a lot o