Thingiverse
The sailor
von Springscrewex
0
Downloads
0
Likes
0
Makes
You're gonna have to drill out the barrel to 5/16 to put a barrel liner in it. !!!ITS MANDATORY!!!
you need a 20mm m3 screw with nut for the hammer and make sure to grind it down, so it has a chisel and a 20 mm for the cocking screw and you have to put two nuts at the end for it to extend out and in the hammer you have to place a nut inside of the hole and line it up when you put it in the body so you can put the screw in. it can use any spring of around 20- 40 mm length and 7-10 od. Also, the pen clip is optional, but if you wanna use it, you would have to have like a short M3 screw like you can have a 20 mm and grind down or cut it and it needs a few spacers. WATCH THE VID TO ASSEMBLE THE PRINT PLSS
Totally just a prop and not real 🤥
to be SAFE print in 100% infill with 6-8 wall loops and use pla + or petg for safeness
heres vid on how to assemble it 😃 made by yours truly 😁
you need a 20mm m3 screw with nut for the hammer and make sure to grind it down, so it has a chisel and a 20 mm for the cocking screw and you have to put two nuts at the end for it to extend out and in the hammer you have to place a nut inside of the hole and line it up when you put it in the body so you can put the screw in. it can use any spring of around 20- 40 mm length and 7-10 od. Also, the pen clip is optional, but if you wanna use it, you would have to have like a short M3 screw like you can have a 20 mm and grind down or cut it and it needs a few spacers. WATCH THE VID TO ASSEMBLE THE PRINT PLSS
Totally just a prop and not real 🤥
to be SAFE print in 100% infill with 6-8 wall loops and use pla + or petg for safeness
heres vid on how to assemble it 😃 made by yours truly 😁
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
