The Shark

This is a "nerf" gun. It is more of a 3D printed pellet gun. It SUCKS it does not shoot far but is fun to build and takes very little filament. I named it The Shark because it kind of looks like a shark when all put together. If you want to build, it will take a rubber band, a spring that fits, an o ring that is tight around the plunger, and a m3 screw at around 25mm long.
To assemble:
First print all the pieces you will need only one of each. The only piece that NEEDS SUPPORT is trigger pt1. Everything else you can use support at your own risk, it may be hard to get out though.

Drop the spring into the plunger tube of the main body

Then tie trigger pt1 and trigger pt2 together with the rubber band

Then slide them into the main body

Make sure the extrusion of Trigger_pt1 pokes into the square hole in the bottom of
Trigger_pt2 and make sure the extrusion of Trigger_pt2 pokes into the hole in the plunger tube of the main body.

Make sure the holes in the main b