Thingiverse
The Skwid lure
door RenMauPer
81
Downloads
54
Likes
0
Makes
A deep diving lure modelled on a squid.
The hollow chambers on the lower side are for ball bearings. I'd recommend 5-7 BBs in the rear chamber and 3-4 in the fore chamber.
Print in 2 halves at 0.2 resolution, put a through wire and BBs in and glue together. Paint, slap on eyes (I like the googly ones), clear coat (if you can), and slip on a skirt (on the lure, in case that wasn't clear).
If printed at this scale, #4 hooks will suffice.
The hollow chambers on the lower side are for ball bearings. I'd recommend 5-7 BBs in the rear chamber and 3-4 in the fore chamber.
Print in 2 halves at 0.2 resolution, put a through wire and BBs in and glue together. Paint, slap on eyes (I like the googly ones), clear coat (if you can), and slip on a skirt (on the lure, in case that wasn't clear).
If printed at this scale, #4 hooks will suffice.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
