MakerWorld
Hueforge & Lithophane
Ver Modelo
The Starry Night - HueForge
1.3k
Descargas
793
Likes
359
Makes
Print at 100% infill with a layer height of 0.2mm with a base layer of 0.2mm. Also, use a brim to prevent lifting in corners. Filaments Used(Try to use similar colors to match my print): Black - Hatchbox PLA Dark silk blue - Generic PLA Light blue - HatchboxPLA Orange - Hatchbox PLA Yellow - HatchboxPLA White - Hatchbox PLA Filament Swap Instructions: Black until layer #9 at 1.8mm Dark blue until layer #12 at 2.4mm Light blue until layer #13 at 2.6mm Orange until layer #14 at 2.8mm Yellow until layer #16 at 3.2mm White for the rest. Note: If resizing STL, leave STL's z-height the same.
jdlg2065 también publica en
6 modelos adicionales en 2 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!