Thingiverse
The Struts Logo
di Filipus
0
Download
2
Likes
1
Makes
This is a slightly modified version of the logo for the band The Struts. I joined the letters in the logo to make it into a one piece object that can then be hanged/taped on a wall, which gives it that nice 3D effect compared to just a sticker or a poster.
There are two versions attached: one flat and angular, created through Sketchup, while the second one used the Smooting feature in Microsoft's 3D builder.
I printed the smooth version on my Creality CR-10S:
- Layer height 0.15mm
- Walls/Top/Bottom thickness: 0.8mm
- Infill density: 20%
For the smooth version, make sure you generate support everywhere, whereas no support is required for the flat version.
Overall, it took just over 4 hours to print at 60mm/s, requiring about 9m of filament.
The result is nice, but I think the flat design might actually end up having a smoother finish, I can't say as I haven't printed that one yet.
Note that neither me nor anyone else should use this design or any derivative for co
There are two versions attached: one flat and angular, created through Sketchup, while the second one used the Smooting feature in Microsoft's 3D builder.
I printed the smooth version on my Creality CR-10S:
- Layer height 0.15mm
- Walls/Top/Bottom thickness: 0.8mm
- Infill density: 20%
For the smooth version, make sure you generate support everywhere, whereas no support is required for the flat version.
Overall, it took just over 4 hours to print at 60mm/s, requiring about 9m of filament.
The result is nice, but I think the flat design might actually end up having a smoother finish, I can't say as I haven't printed that one yet.
Note that neither me nor anyone else should use this design or any derivative for co
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!