The Sun

Here is a Hueforge print of the sun. For the one shown in the picture, I used Bambu PLA Basic for the red and orange, and Sunlu PLA Meta for the black and white. The instructions are as follows: Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Swap Instructions: Start with Black At layer #7 (0.64mm) swap to Red At layer #12 (1.04mm) swap to Yellow At layer #19 (1.6mm) swap to Jade White for the rest. Filaments Used according to Hueforge: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Red Transmission Distance: 5 PLA BambuLab Basic Yellow Transmission Distance: 6 PLA BambuLab Basic Jade White Transmission Distance: 5