Thingiverse
THE Surface Pro Stand
von kieranh45
5
Downloads
6
Likes
0
Makes
I needed a larger print to test some filament and I needed a tidier, reliable stand to store my surface pro on the desk. So I made the THE Surface Pro Stand.
The wide base means I haven't had to worry about kocking it over.
Most slim laptops and tablets should fit in no worries but a Surface Pro with cover should feel just right.
Layer Height: 0.2 mm
Material: All, PLA recommended
Infill: 10%
Infill Parttern: Pay close attention to your slice on the internal chamfers. A hex pattern can result in holes on the top surface due to being unsupported. Linear pattern recommended.
The wide base means I haven't had to worry about kocking it over.
Most slim laptops and tablets should fit in no worries but a Surface Pro with cover should feel just right.
Layer Height: 0.2 mm
Material: All, PLA recommended
Infill: 10%
Infill Parttern: Pay close attention to your slice on the internal chamfers. A hex pattern can result in holes on the top surface due to being unsupported. Linear pattern recommended.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
