Slicer Discord
The ultimate MAXIM rocket – Modelo 3D imprimible de MakerWorld MakerWorld
Other Hobby & DIY

The ultimate MAXIM rocket

54 Descargas
18 Likes
36 Makes
Ver Modelo
MAXIM (Maximum Acceleration, eXtreme Impulse, Minimum Size)MAXIM is a small rocket. It is small but effective and it can shoot across the room or up to 5 feet in the air.After you put the rocket into the launcher, you have to squeeze just below the top of the launcher in order to get a powerful launch.If you’re squeezing as hard as you can but the rocket is not being blasted, then just take the rocket out and put it back in and try it again.It could also be because that the plastic is wearing out. Plastic stretchiness does not last forever! It could get too stretchy and the launcher would not have enough power.For storage, you can put the rocket into the launcher like this: The circled spike goes inside the loop of the rocket.Boost MePlease boost. Free. Boost your favorite models.
Categoría
Other Hobby & DIY
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

Larry12345 también publica en

2 modelos adicionales en 1 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección