Thingiverse
Thermometer Holder
door UtopianKing
4
Downloads
3
Likes
0
Makes
The one in the picture is an older version.
-Backplate thickness corrected
-Adjustments made to the hang hole.
-Upper "jaw" aesthetics corrected to fit the rest of the design (chamfered the top edge)
-Cable pass widened behind the cylindrical part
If used for other purposes, here are some numbers to see if it fits:
The thermometer dimensions
Height 54 mm
Width 14 mm (Thickness of the device)
Length 64 mm (This dimension has little to no relevance on the design)
The diameter of the cylindrical part is Ø 15 mm
The holder is 20 mm wide
Print time: 27 minutes
Filament used: 3.51 meters of PLA
Estimated material cost (PLA): ~0,32 €
(Calculated from 200 m spool with a price of 17,99 € ≈ 0.08995 / m)
-Backplate thickness corrected
-Adjustments made to the hang hole.
-Upper "jaw" aesthetics corrected to fit the rest of the design (chamfered the top edge)
-Cable pass widened behind the cylindrical part
If used for other purposes, here are some numbers to see if it fits:
The thermometer dimensions
Height 54 mm
Width 14 mm (Thickness of the device)
Length 64 mm (This dimension has little to no relevance on the design)
The diameter of the cylindrical part is Ø 15 mm
The holder is 20 mm wide
Print time: 27 minutes
Filament used: 3.51 meters of PLA
Estimated material cost (PLA): ~0,32 €
(Calculated from 200 m spool with a price of 17,99 € ≈ 0.08995 / m)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
