Thick Lacquering for PLA Models

Fill the remaining grooves on the surface of the PLA models and build a thick coat to further protect it.
This way is suitable for models with simple shapes, but it is not suitable for models with complex shapes.

##⚠Cautions
- Ventilate the room during painting/drying/vaporing
- Do not place the painted PLA models near the fire

##🛒Requirements
###🎨For Lacquering
- 1 x Sanding sealer
- Choose a sanding sealer containing nitrocellulose as a substrate
- Choose a sanding sealer with high ratio of ethyl acetate or butyl acetate as solvent
- Use as a top coat of third layer
- If you are concerned about patterns appearing on the painted surface, use the nail top coat
- In case of emphasizing safety, it is good to use paint not containing nitrocellulose as top coat (However, smoothing with acetone vapor becomes impossible)
- Mix with starch or ink respectively to use for under/middle coat of second/third layer
- When mixing, s