Thing 1 and Thing 2

"Would you like to shake hands
With Thing One and Thing Two?" -The Cat in the Hat

I noticed that Thingiverse didn't have a "Thing" in it... so...

My filament colors are a bit off. The colors should be red, white, and cyan/light blue.

A fine tip permanent marker seems to work for the labeling and, if you want, drawing in the face.

I've included built-in supports for the few parts that needed them.

In order to align the parts, I've left a slot that accepts 1.75mm filament. The slot is 2mm, but you may need to open it up using heat or a file. It can close up due to first layer flattening.

"And then he was gone
With a tip of his hat."