Thingiverse
Thingamajig
von jwdiana
1
Downloads
0
Likes
0
Makes
This is a Thingamajig I created to study making holes in things with OpenScad. Not really useful for anything except a study piece(code included).
I printed it upside down and listing at an angle(see first thing photo) to try to get the least amount of support. It seemed to be a bit of a challenge for the printer on the sphere with two holes but it did OK.
It was fun to rotate the drawing in OpenScad and look in the holes so I decided to print it. The large cube is 80x15x80.
I printed in PETG but any filament will do.
I printed it upside down and listing at an angle(see first thing photo) to try to get the least amount of support. It seemed to be a bit of a challenge for the printer on the sphere with two holes but it did OK.
It was fun to rotate the drawing in OpenScad and look in the holes so I decided to print it. The large cube is 80x15x80.
I printed in PETG but any filament will do.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!