Thingiverse
Thingy that shoots
door 3dPrinting_99
81
Downloads
104
Likes
0
Makes
This is a redesign of this thingy.
https://www.thingiverse.com/thing:4856212
It's basically the same, but better.
Now it can be printed without supports!!!
Notes: On the video I forgot to mention about the pen spring. It's required for the magazine lock.
You should watch the video. Print everything on 0.1mm layer height and lubricate properly. The frame and slide could be printed at 0.2mm layer height, but for the rest a lower layer height is mandatory. 0.4mm nozzle, use PLA, nozzle speed at maximum. Good bed level and bed adhesion. The usual.
Video:
https://youtu.be/RZUOnDcpIRQ
https://www.thingiverse.com/thing:4856212
It's basically the same, but better.
Now it can be printed without supports!!!
Notes: On the video I forgot to mention about the pen spring. It's required for the magazine lock.
You should watch the video. Print everything on 0.1mm layer height and lubricate properly. The frame and slide could be printed at 0.2mm layer height, but for the rest a lower layer height is mandatory. 0.4mm nozzle, use PLA, nozzle speed at maximum. Good bed level and bed adhesion. The usual.
Video:
https://youtu.be/RZUOnDcpIRQ
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!