Thinker S Power Supply Unit Mod

This is a powersupply mod for the Eryone Thinker S.
With this mod you put your annoying, sidestanding powersupply direct under your printer.

Eryone rollout some different Types of the Thinker S without any sense.
So at first: check picture two (fits.jpg) if your printer is suitable!

You will need following Screws:
* 13 M4x10 Screws
* 9 M4 T-Nuts
* some zipties

1. After you printing it like the pcitures above tells you, you have to screw up the XT60-Adapter on your right side of your printer.

2. Then you screw apart your powersupply from the plastic-cover (including the cables and adapter)

3. Next you screw the powersupply into the frame (4 M4 screws at the side; take a closer look to the pictures in which orientation)

4. Then screw the frame under your printer like shown in the pictures

5. After that you should connect the XT60-Cable back to the powersupply and do some cable management around the suply (like picture numer 7)

6. then you should connect t