ThinkPad vertical stand

#ABOUT
Most of the other stands out there are slightly tilted, whereas I wanted something that held my ThinkPad straight up.

The "skeleton" design is intended to reduce material usage while increasing strength.

The Fusion 360 source file is included to make it easier for you to make changes or remixes.

**If you have suggestions for improvements, please post in the comments. I am definitely open to adding revisions.**


# Fit and resizing
I designed it around the dimensions of my ThinkPad 460s, but it should fit other ThinkPad models as well (I also successfully tested a ThinkPad Yoga). My 460s is about 14.5mm thick (including the rubber pads) right about where it rests in the stands. If yours more or less than 14.5mm at the same spot, you will want to resize the model. There are two ways to go about this.

First way would be to edit the model using the Fusion 360 file that is attached.

The second and easier way would be to simply scale the model in your slicer. For e