Thinner Pi Camera (Fits Voron)

This is a thinner version of PI Camera (Fits Voron 2.4). Use at your own discretion, it has not been tested yet but will soon be tested on a 350. all parts that extend above the bed are 8.5mm thick max and are as close as possible to the plexiglass panels. Also the ribbon cable runs through the center of the arm. There is a standard size and an extended version (8mm longer) for those with kinematic bed mounts. No supports necessary if your bridge settings are on point.

It's been reported to still be interfering with the toolhead on the 350.