Thinner Wall Mounted Drybox

I wanted a thinner drybox to store filament in when not being used and didn't need holes or rollers for the bearing.Much simpler build AND Uses about 70% of the filament as the original drybox!!!Update 3/10/23 - I got tired of fighting with supports for the little latch alignment knob on the bottom half so I cut off a bit of it so now SUPPORTS ARE NO LONGER NEEDED!!! WOOT WOOT!!! also I uploaded a couple test files.Update 3/5/23 - I had endless problems with extrusion issues on the rims of the bottom sections. also, the latch never aligned properly. I tried numerous settings and never got it completely fixed until i went back to basics. I scrapped everything and downloaded the original files from the original Prusa drybox. What I did:Sliced them up, squeezed the edges together until they were 80mm apart (the width of the swatch card holder).Added a couple little bits under some ledges to remove the need for supports.Cut out the saddles for the bearings. Use This if you want the spool t