Thingiverse
This Blacksmith Puzzle
por Lodo3
18
Descargas
12
Likes
0
Makes
I saw this puzzle on reddit: (Warning Spoilers)
https://www.reddit.com/r/Damnthatsinteresting/comments/je2vf1/this_puzzle/
and thought, I could 3D print that!
I modelled it in Fusion 360. No supports are required. I used bridging to avoid any support.
Please be aware that in Fusion 360 I used cm, but when I exported to STL, the file was in mm, so you will have to scale it up to 1000% to be full size. I printed it as small as 500%, and it still worked. I haven't tested any smaller than that.
I hope you enjoy the puzzle!
EDIT: I added an updated rod that should cut down on print time, and not break as the other one was prone too. It is a 3mf file and so the units are in cm.
https://www.reddit.com/r/Damnthatsinteresting/comments/je2vf1/this_puzzle/
and thought, I could 3D print that!
I modelled it in Fusion 360. No supports are required. I used bridging to avoid any support.
Please be aware that in Fusion 360 I used cm, but when I exported to STL, the file was in mm, so you will have to scale it up to 1000% to be full size. I printed it as small as 500%, and it still worked. I haven't tested any smaller than that.
I hope you enjoy the puzzle!
EDIT: I added an updated rod that should cut down on print time, and not break as the other one was prone too. It is a 3mf file and so the units are in cm.
Lodo3 también publica en
6 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!