Thomas the Death Star

After Thomas the TIE fighter, this is Thomas the Death Star.
Here is a humorous depiction of what you can expect if you print this: https://youtu.be/sFYB0RJr7JA

You will need to print the top and the base as well as the face. The face can be glued or attach with magnets.

Optional parts list:
>-Two 8x1mm circular magnets if you want the face to be removable. The magnets will need to be glued.
>-If you want it to swivel you will need 1x 9g servo + relevant RC equipment* of choice
>-2x 6mm laser diodes if you want laser eyes (https://www.banggood.com/custlink/GDKRI5daet)
>-1x 3mm LED if you want the eyes to glow.

*: RC equipment to control the servo:
>If you want to go as cheap as possible and you could use Servo Tester (https://www.banggood.com/custlink/3D3Y9bDgtA)
>If you want to go RC you could get a Flysky radio + FS iA6B receiver (https://www.banggood.com/custlink/KK3d8bD483). Note: The iA6B won't fit inside.
>If you want to get fancy you could use an Arduino